BJ-9000 · Bluetooth Programmer

v · writes channels & zone names only · settings, APRS, calibration untouched
Same hardware and programming protocol; this sets the names the app expects.

1Connect

Radio on, Bluetooth on (radio menu), not connected to the manufacturer phone app.
Not connected.

2Read radio & save backup

Reads ~260 blocks (about 1–2 min). Nothing is written.

3Channels to write

Pick a .zip zone package or your CHIRP-format zone files (multi-select), named ZoneNN_NAME.csv, e.g. Zone03_LOCAL.csv = zone 3 named "LOCAL". A zip is read directly on the phone, no unzipping needed; CSVs inside sub-folders are found too. A zone file replaces that whole zone; zones without a file are left alone.
No channels loaded.
Add CB 40 channels (27 MHz)
US CB channels 1–40, simplex, no tones. The radio transmits FM only on 27 MHz. To use them, switch the radio to Menu › Radio Set › Work Band › 18–64 MHz (the radio restarts) and fit a 27 MHz antenna; switch back to 64–999 MHz for VHF/UHF.

4Write to radio

Read the radio first.

AAPRS settings

Edits only the radio's APRS settings block. APRS transmits on the frequency of the channel/VFO it is set to use — put your APRS frequency (144.390 MHz in the US) in a channel. Labels marked * have an unconfirmed value mapping: their current raw value is shown and left alone unless you change it.
Connect first.

↺Restore from backup

Puts channels and zone names back exactly as saved.
Advanced
Log

      

Write to radio?